InspectAPedia ^TM

Replacement FPE Stab-Lok Electrical Panels - What if I Can't Afford a New Panel? FPEaPedia © Enter your search terms Submit search form   Search This Website - InspectAPedia.com

• What to do if you cannot afford to replace an FPE Stab-Lok electrical panel
• Steps to increase electrical safety in the home
• Planning for electrical panel replacement

We recommend that the FPE Stab-Lok electrical panel be replaced entirely. We recommend against replacing individual FPE Stab-lok circuit breakers. This web page explains the issues and recommends solutions for people looking for a replacement FPE Stab-Lok circuit breaker. We do not sell circuit breakers nor any other products.

This document describes steps to take if you are unable to promptly replace an Federal Pacific Stab-Lok Electric Panel. Here we address the question raised by some readers about what to do if you can't afford to replace an FPE Stab-Lok electrical panel right away. Readers should see THE FPE Stab-Lok WEBSITE and also see ADVICE TO HOME BUYERS w/ FPE PANELS .

This is information for home owners, home sellers, building inspectors, home buyers, home owners, and electricians regarding steps to reduce the hazards associated with Federal Pacific Electric Stab-lok circuit breakers and service panels. Safety warning: as with any electrical installation or repair, these steps must be performed by a licensed and qualified electrician and must comply with appropriate building codes and regulations. Good workmanship and an accurate assessment of the condition of the electrical panel enclosure which is to be re-used are important for FPE Electric Panel .

Also see THE FPE Stab-Lok WEBSITE- the main FPE Hazard Website. © Copyright 2008 Daniel Friedman, All Rights Reserved. Information Accuracy & Bias Pledge is at below-left. Use links at the left of each page to navigate this document or to view other topics at this website. Green links show where you are in our document or website.

What to Do if You Cannot Replace an FPE Stab-Lok Electrical Panel

What if Up to Now the FPE Panel Has Seemed Just Fine?

Our breakers have already tripped: One reader reported that some of her FPE Stab-Lok circuit breakers have tripped correctly in the past. That was good to hear; we don't assert that the failure rate on these circuit breakers is 100% of the time, but in fact the failure-to-trip rate occurs enormously more often than on other non-problem electrical panels and circuit breakers.

A problem is that we can't predict when an overcurrent or unsafe electrical condition is going to occur in a building, and we cannot predict exactly when an individual circuit  breaker is going to fail to protect the circuit and thus the building from an overcurrent or electrical short.

But reporting that "up to now the panel has been fine" or "up to now we've never had a problem" or even "up to now the circuit breakers in our FPE panel have tripped off", is not any assurance that such a system is safe. We've seen that if you do trip an FPE Stab-Lok breaker, that event can actually increase the chances that it will jam and not trip next time.

Our inspector said the panel looked ok to him: visual inspections of the electrical panel or even in-place electrical "tests" of the panel are either unreliable or downright dangerous. You cannot rely on such superficial or inexpert tests, and the very fact that they are offered by some is evidence of a lack of expertise on this topic.

Here's what you can do while waiting to replace your FPE Stab-Lok electrical panel:

1. Don't panic - panic leads to getting over charged by the electrician. But get bids from at least two electricians experienced in electrical panel replacement.  Plan to replace the panel; do not rely on visual inspections or "tests" that might claim that the panel is safe.
   
   
2. Make certain you have working smoke detectors in the home and that they are installed in the locations and in the manner recommended by their manufacturers or in local fire safety codes.
   
   
3. Read up and become accurately informed about FPE Stab-Lok equipment: see THE FPE Stab-Lok WEBSITE. Don't be fooled by some of the nonsense articles posted online in which a few folks claim FPE Stab-Lok circuit breakers & panels are not a problem - there is ample court record as well as soundly researched evidence about this equipment and its failure rates.
   
   
4. Obtain electrical panel replacement bids from at least two electricians in your area. Once you have an accurate idea of what panel replacement is likely to cost you will know how much you'll need to save or borrow. See FPE REPAIR ELECTRICIANS
   
   
5. Start saving up to replace your FPE Stab-Lok electrical panel as soon as you can. There is no meaningful financial relief available from the company; there has been some limited financial relief for original homeowners in New Jersey where FPE Stab-lok equipment was installed.
   
   
6. Save on electrical panel replacement cost: See http://www.inspect-ny.com/fpe/fpereplace.htm which for some installations can cut the electric panel installation cost in half. Depending on your financial situation, the condition of the home and its electrical wiring, and the existence of other risk factors such as elderly or otherwise immobile occupants who might have trouble escaping a fire, it may be appropriate to borrow the cost to replace an unsafe electrical panel, or local community welfare agencies may be able to help offset that cost, or an electrician may agree to perform the work at a reduced rate.
   
   
7. Do your best to avoid overloading electrical circuits - overloading a circuit means plugging in too many high-energy devices like heaters. That will reduce the chances of a circuit overload and breaker failure. It won't prevent a dangerous circuit breaker failure should there be an "event" like a short circuit in an electrical appliance however.
   
   
8. Turn off or replace unsafe electrical circuits or equipment: If there are any circuits that are behaving funny - flickering lights, turn off that circuit. But beware: one of the FPE Stab-Lok defects is that while you might turn off the breaker by flipping the toggle switch, the breaker may not really be "off" - its internal parts may be stuck in the "on" position. An electrician trained in how to use a multimeter or a simple neon tester can check to be sure that the questionable circuit is really "off" by testing for power at an outlet or light fixture on the circuit that is supposedly turned "off".
   
   
9. Check for and repair or replace any unsafe electrical devices such as lights or appliances that themselves are in poor condition and are at extra risk of causing a short circuit.
   
   
10. Assess the general level of safety & fire-risk in the building: first there may be other more immediate fire or safety hazards in a home, such as unsafe heating equipment or chimneys, gas leaks, or even tripping and falling hazards that produce injuries at a high rate of occurrence. The condition of the home and its electrical wiring, the existence of other risk factors such as elderly or otherwise immobile occupants who might have trouble escaping a fire, are examples of factors that increase the level of risk in a home. Where the risk of an electrical problem is greater (old wiring in poor condition for example), or where the risk to occupants is greater (elderly or immobile occupants), the urgency of correcting these unsafe conditions should also be considered greater.
    
    
11. Check to assure that your building is properly insured and that your insurance company will not exclude a loss related to the presence of an FPE Stab-Lok electrical panel in building. Some insurance companies or their individual branch offices may exclude coverage for buildings with this equipment installed. Don't play "dumb" and fail to tell your insurance company - doing so could void your insurance coverage.

If I can think of more suggestions, or if you find any others, let me know. Luckily it's not the case that every single failure of a circuit breaker to trip off when it should burns down the house. But the $1000 or so to replace an electrical panel is probably much cheaper than the cost of a fire should one occur.

More Information about FPE Federal Pacific Stab Lok Panels and Circuit Breakers - Reference List

• The Federal Pacific Stab-Lok Electric Panel Hazard Website Safety Information for Consumers. 1983
• How to Identify Federal Pacific Electric Panels Stab Lok Breakers & History of the Federal Pacific Electric Stab Lok Hazard
• Replacement Electric Panels: Federal Pacific Electric Panel Replacements two cost and method options for FPE panel replacement.
• Home Inspection Reporting Language for FPE Stab-Lok electric panels and circuit breakers
• Schneider Canada Federal Pioneer circuit breaker recall
• FPE FIRES: Failures continue: FPE breaker fails, results in fires: field reports
• Federal Pacific Electric Fires Waiting to Happen, Debate Waiting to Be Ended, detailed article
• 1983 CPSC Investigation of FPE Circuit Breakers Safety Information for Consumers
• 1982 Reliance Electric Co. SEC Quarterly Report: Note C. reports litigation between Reliance and UV Liquidating Trust and contends that "... improper and deceptive practices were employed for many years to secure UL listings for Federal Pacific's circuit protective products..."
• 1980 Reliance Electric Co. Press Release: improper practices improper practices used to obtain UL Listing for most of FPE's circuit breakers and notes testing which indicates "possible defects." 1980, Reliance Electric Co.
• 1980 FPE - Exxon Buys A Scandal Along With A Company improper practices improper practices used to obtain UL Listing for most of FPE's circuit breakers and notes testing which indicates "possible defects." 1980, Reliance Electric Co.
• FAQ: Website Credibility

InspectAPedia ^TM Home & Site Map - Building Inspection, Diagnosis, & Repair, Environmental Inspection & Testing - Research Website

Home Inspection Construction Consulting Services & advice for home buyers

Contact Daniel Friedman for website content suggestions or for fee-paid consulting

	Enter your search termsSubmit search form
	Search This Website - InspectAPedia.com