InspectAPedia ^TM

The Water Pump Relay Switch on Private Well and Pump Systems WaterAPedia © Enter your search terms Submit search form   Search This Website - InspectAPedia.com

• How to Find & Use the Water Pump Relay Switch, will one be installed on your system? if so where is it? what does the pump relay do? Why is it needed?
• Well pump & water tank diagnosis & repair procedures

This article describes How to Find & Use the Water Pump Relay Switch. The page top photo shows a typical wall-mounted Goulds (TM) relay switch used to power a submersible well pump. Readers of this document should also see Water pump and pressure tank repair diagnosis & cost an specific case which offers an example of diagnosis of loss of water pressure, loss of water, and analyzes the actual repair cost. © 2008 Daniel Friedman, All Rights Reserved. Information Accuracy & Bias Pledge is at below-left. Use links at the left of each page to navigate this document or to view other topics at this website. Green links show where you are in our document or website.

How to Locate & Use the Water Pump Relay Switch

How to Recognize and Locate a Pump Relay Switch In this photograph a pump relay switch is mounted on the wall to the left of the blue water pressure tank. You'll notice that an electrical conduit can be seen running down the wall below this gray switch box. The relay is usually mounted on a wall near the water pressure tank. How are Water Pump Relay Switches Wired & Controlled? Electrical power, either 120V or 240V, is brought into the relay switch from the electrical panel and is connected to one side of an internal relay switch inside the box. Wiring to the water pump, usually a submersible pump located inside the well, is connected to the other side of the relay switch. A separate pair of wires will run from the relay switch to the pump pressure control switch. (See that little gray box at the lower end of the conduit below the larger, wall-mounted gray pressure switch box?). When the pump pressure control switch detects that the water pump should turn on, a light-duty switch inside of the water pump pressure control switch senses this pressure drop and turns on the heavy-duty electrical relay switch inside of the wall mounted pump relay. The wall mounted relay thus is sending power to the water pump.

When do we use a pump relay switch

A pump relay switch such as the relay switches shown in photographs in this article is used to power a water pump when the voltage/amperage combination would be too much to switch on and off by the simple pump pressure switch.

It is possible to power smaller horsepower (lower amperage-drawing) submersible pump directly from the pump pressure control switch. While you'll see even some submersible pumps wired this way (that is the wall mounted heavy duty relay switch is not provided), larger horsepower submersible well pumps draw sufficient amperage that if they were wired through a little pressure control switch at the water tank that switch would burn up pretty quickly.

When are pump relay switches not used?

Pump relay switches are not installed on every water pump, and are usually not found when the water pump is above ground such as when a one line or two line jet pump is installed at or near the water pressure tank.

Combined Heavy Duty Pump Relays and Pressure Controls Some heavy duty submersible pump relays such as the Homat(TM) switch shown in this photograph combine the pressure control sensor and the heavy duty pump elecrical relay switch. Notice the copper tube entering the pump relay box at the lower right in this photo? Also notice that this switch has a pressure gauge right on the switch box face. This pump control switch has combined a water pressure sensor and switch with the relay to send power to the water pump. So inspecting the rest of the water equipment at this building we won't expect to find that ordinary little <"HREF=http://www.inspect-ny.com/water/PressureSwitch001DJFs.jpg">gray box which controls pump operation on a lower horsepower water pump.

Where is the "electrical ON-OFF switch" when a wall mounted heavy duty pump relay is installed?

We may not see a separate wall mounted electrical switch by the pump controls when a heavy duty relay such as those discussed here is installed. Rather, on at least some of these switches, pulling off the cover of the relay box will actually disconnect internal components and thus serves as a local electrical switch for the water pump.

Safety warning live voltage is inside of all of these pump switches - and is a shock hazard. When you don't see an ordinary wall switch to turn off the water pump you're probably safer going to the electrical panel where you can turn off power to the water pump by switching off the appropriate circuit breaker or pulling the appropriate fuse.

Water Tank Maintenance & Repair Chapter Index

Use links just below or at the left of each of the pages at our website to navigate this document or to view other topics at this website. Green links show where you are in our document or website.

PLUMBING TOPICS
OIL TANKS
SEPTIC SYSTEMS
WATER PRESSURE REPAIR GUIDE & COSTS
WATER PRESSURE LOSS DIAGNOSIS GUIDE
WATER PUMPS & TANKS & WELLS
WATER PUMP CONTROLS & SWITCHES
  IDENTIFY WELL PUMP TANK COMPONENTS
  MAIN WATER SHUTOFF VALVE
  PUMP ELECTRICAL SWITCHES
  PUMP PRESSURE CONTROL
    WATER PUMP PRESSURE CONTROL ADJUSTMENT
    WATER PUMP PRESSURE CONTROL REPAIR
    WATER PUMP PRESSURE CONTROL REPLACE
  PUMP RELAY SWITCH
  TANK AIR VOLUME CONTROLS
  TANK AIR INLET VALVE
  TANK AIR VALVE REPAIRS
  TANK PRESSURE GAUGE
  TANK DRAIN VALVE
  TANK RELIEF VALVE
  CHECK VALVES
  WATER FILTERS
PUMP TYPES & LIFE EXPECTANCY
WATER PUMP & TANK SAFETY
WATER SUPPLY & DRAIN PIPING
WATER TANK TYPES: WATER, OIL, EXPANSION, ALL
WATER TANK LIFE EXPECTANCY
WATER TANK REPAIRS
WATER TANK AIR, HOW TO ADD
WATER TANK PRESSURE CALCULATIONS
WATER TANK SIZE & VOLUME
WATER TANKS HOW THEY WORK
WATER TESTING
WELLS CISTERNS & SPRINGS
WELL, PUMP, TANK LIFE EXPECTANCY

Technical Reviewers

Particular thanks are due to experts and also consumers who read these articles and suggest corrections, changes, and additions to the material. Content suggestions, technical corrections and content critique are invited for any of the content at our website.

• Daniel Friedman - principal author/editor of the InspectAPedia ^TM Website
• Critique, contributions wanted: Contact Us to suggest text changes and additions and, if you wish, to receive online listing and credit for that contribution.

environmental hazards residential properties for home buyers home owners contamination water damage,ASHI American Society of Home Inspectors Air testing ASHI home inspections inspectors (C)trap Daniel Friedman, Construction failures drinking water contamination contaminants lead, pesticides, organics lead paint hazard advice,

More expert information on this topic

More Information on Plumbing & Other Building Diagnostic Inspections and Repairs

Plumbing Diagnosis & Repair: Water supply, drainage, septic systems, water testing, water contamination, defective plumbing materials & products.

• Water pump and pressure tank repair diagnosis & cost an specific case offers an example of diagnosis of loss of water pressure, loss of water, and analyzes the actual repair cost
• Water pressure tank failures & water pump short cycling diagnosis and repair
• Cheating on water tests: Testing Water for Real Estate Transactions - make sure your water test is valid
• Drinking Water Testing Advice for home buyers home owners home inspectors
• Interpreting Drinking Water Test Results and Correcting Unsatisfactory Water
• Drinking Water Contaminant Levels - Maximum Allowed
• Lead Contamination in Drinking Water: Testing & Correction - Advice (This Article)
• Lead Testing & Correcting Contamination from Lead Water Supply Lines/Entry Mains - Lead Pipe Problems/Advice
• Water testing for Pesticides: comprehensive and pesticides-example parameters
• Water Testing: background comments on classes of water contaminants, & links to home buyer advice about water testing, drinking water, water supply
• When and How to Shock or Chlorinate a Well - Procedure for Shocking a Well to (temporarily or maybe longer) "Correct" Bacterial Contamination
• Water Requirements, Home & Outdoor Living
• Typical Water Tests & Fees this water test fee schedule applies when testing is combined with other onsite building inspection services
• Drinking Water testing, contamination, correction - all topics
• General water testing and corrective measure advice: contact your local health department.

Building & Building Inspection, Environmental Inspection/Testing, Construction Diagnosis & Repair - Research Website

Home Inspection Construction Consulting Services & advice for home buyers

Contact Daniel Friedman for website content suggestions or for fee-paid consulting

	Enter your search termsSubmit search form
	Search This Website - InspectAPedia.com